Popcorn Machine Add On
- Actual Size: 2x2
- Setup Area: 2x2
- Outlets: 1
- Age Group: 18+ For Operation
- Attendants: 1
Setup popcorn machine on a secure table top.
Plug in power cord into a 120V, 15 Amp circuit. Be sure electrical source is sufficient to properly power machine.
There are three switchers on the popper.
LIGHT AND WARMER SWITCH – Turns on heat to bottom corn pan and light.
KETTLE MOTOR SWITCH – Turns on motor, which drives kettle agitator shaft.
KETTLE HEAT SWITCH – Turns on heat element.
Turn kettle heat and kettle motor switch “ON”. Allow 3-5 minute sfor kettle to warm.
Pour about 6-8 ounces of prepared kernels into kettle.
When corn has finished popping, dump kettle.
Repeat steps 2 and 3 again (there is no need to warm kettle after first time).
Once you have made enough popcorn to fill bottom compartment, turn motor switch and heat switch off. Turn on light and warmer switch to keep popcorn warm.
Empty bottom corn pan after you have finished making your popcorn.
Caution: Do not touch the kettle while on; it is hot and can cause serious burns.
Leaving popcorn in kettle for too long can cause popcorn to burn.
If a batch of popcorn has been burned, you must first clean the inside of the kettle before preparing another batch.
INCLUDES: Machine, Kernals, Bags (50 Servings)